QwikPad® for Condensers
- Lightweight
- Easy-to-install
- Meets wind loading requirements up to 180 mph
- Includes corrosion-resistant stainless steel tie-down assemblies
QwikPad Features & Benefits
Lightweight 29lbs for transport
Hurricane-rated up to 180mph
UV Resistant
Made in Florida, USA
QwikPad® Anchor Kits
Optional Soil and Concrete Anchor Kits provide additional hurricane protection, stabilization, and theft protection when needed.
Interested in QwikPad?
Recent Installs
Kittery, ME
- Units 286
- Location 41 Seacoast Terrace, Kittery, ME 03904
- Architect Cube 3
- Contractor Atlantis Comfort Systems
Nashville, TN
- Units 40 growing to 300
- Location Livano Nations
- Builder LIV Development
- Contractor LandSouth Construction
Houston, TX
- Units 240
- Location Columbia Senior Residential
- Architect JHP Architecture
- Contractor Block Construction
Knightdale, NC
- Units 239
- Location The Lofts @ Knightdale
- Architect Brown Investment Properties
- Contractor Windsor Mechanical
Cary, NC
- Units 360
- Location Abberly Alston
- Architect HHUNT
- Contractor American Mechanical
Myrle Beach, SC
- Units 280
- Location Hawthorne @ The Mill 208
- Architect The Sembler Co.
- Contractor American Mechanical
Online Retailers
For bulk orders contact us directly
Call (321) 631-3550
Videos
Learn more about QwikPad
Call (321) 631-3550
Additional Resources
Engineering
Documentation
*SEE FULL INSTALLATION INSTRUCTIONS INCLUDED WITH PRODUCT PURCHASE NOTE: In areas that experience freezing temperatures, only fill the QwikPad® for Condensers 80% full for increased lifetime. This can be done by only filling the pad with water to a depth of 2.3 inches – when filling, use a dip-stick or straw to periodically check liquid height. Verify that an 80% fill still meets local wind regulations through our online calculator and information. This depth is true for both the 36 in and 40 in pad.
- Choose acceptable equipment pad size and anchoring method that meets wind loading requirements in your area. Use the load tables included with the QwikPad® for Condensers.
- Tip pad towards fill port corner. This will cause gelling agent to collect near fill port for proper distribution when filling.
- If necessary, embed pad 1" deep in level compacted ground. Otherwise, simply place pad on level compacted ground in desired location.
- Fill pad with tap water - DO NOT OVERFILL. Water will solidify into gel over time.
- Install concrete or ground anchors, when required.
- Secure the equipment to the pad using included hardware and tie-down assemblies.
FAQ
Have questions about QwikPad?