QwikPad®

for Condensers + Accessories

QT8036 | QT8040

Weighs only 29 lbs when
unfilled & 162 lbs filled

Lightweight wind-rated pad up to 180mph

UV Resistant, Ultra-Durable, & Warranty Protected

Made on the Space Coast in Florida, USA

QwikPad® for Condensers is a lightweight, easy-to-install condenser pad that meets wind loading requirements up to 180 mph. Includes corrosion-resistant stainless steel tie-down assemblies to secure the outdoor unit to the pad.

LEARN MORE

Specifications

QwikPad® For Condensers

The only lightweight, easy-to-install, condenser pad that meets hurricane-rated wind loading requirements up to 180 mph (QT8036 & QT8040)

Dimensions: 36x36x4, 40x40x4
Material: Linear Low Density Polyethylene
Pad Weight (Empty): 29 lbs, 35 lbs
Pad Weight (Filled): 162 lbs, 200 lbs
Rated Wind Speed: 180 MPH

The Florida Building Code rated air conditioning support pad is lightweight when purchased, but weighs enough to meet code requirements up to 180 mph wind loading when filled with water and secured with stainless steel tie-down assemblies (supplied). Each pad includes a unique gelling agent that, once water is added, forms a solidus gel. Optional ground and concrete anchors provide additional hurricane protection when needed.

QT8036

Dimensions	36” x 36” x 4”
Pad Weight (Empty)	29 lb
Pad Weight (Full)	162 lb
Maximum Condensing Unit Size	32” x 32”

QT8040

Dimensions	40” x 40” x 4”
Pad Weight (Empty)	35 lb
Pad Weight (Full)	200 lb
Maximum Condensing Unit Size	36” x 36”

CLICK TO VIEW PRINTED INSTRUCTIONS

NOTE: In areas that experience freezing temperatures, only fill the QwikPad® for Condensers 80% full for increased lifetime. This can be done by only filling the pad with water to a depth of 2.3 inches – when filling, use a dip-stick or straw to periodically check liquid height. Verify that an 80% fill still meets local wind regulations through our online calculator and information. This depth is true for both the 36 in and 40 in pad.

Choose acceptable equipment pad size and anchoring method that meets wind loading requirements in your area. Use the load tables included with the QwikPad® for Condensers.
Tip pad towards fill port corner. This will cause gelling agent to collect near fill port for proper distribution when filling.
If necessary, embed pad 1" deep in level compacted ground. Otherwise, simply place pad on level compacted ground in desired location.
Fill pad with tap water - DO NOT OVERFILL. Water will solidify into gel over time.
Install concrete or ground anchors, when required.
Secure the equipment to the pad using included hardware and tie-down assemblies.